Home  -  News - News

Shot blasting machine operation procedure

Nov. 25, 2019
Share:

Shot blasting machine is a kind of processing technology that impacts steel sand steel shots on the surface of material objects by blasting machine at high speed.

Operating procedure

1. Operate the road shot blasting machine and strictly carry out the fixed-post training, and be familiar with the performance and characteristics of the machine.

2. Familiar with the operation procedures, use, maintenance and maintenance in the instruction manual of shot blasting machine.

3. The operator must check whether the various switches of the control cabinet (panel) are in the required setting position (including each power switch) before starting the machine to avoid malfunction, damage electrical and mechanical equipment, and cause equipment accidents.

4. Non-operator operators are not allowed to operate or touch the electrical switch control area at will, and should not be close to the working area of the machine to avoid accidents.

5. The operator must wear protective overalls, glasses, etc.

6. When the operator starts up, pay special attention to the various types of instrument indications on the panel. When all the indications of the instruments reach the normal value, the small crane (roller) can be operated to enter the working procedure. If it is found that the individual meter indicates a large error (not normal), immediately shut down. Check the concrete shot blasting machinefault processing before it can start working normally.

7. During the operation of the equipment, the operator must patrol the equipment to check for abnormal noise and overheating of various parts. When the equipment is found to have a serious fault during operation, press the "Emergency Stop" button to stop the repair, and cooperate with the professional to eliminate the equipment failure.

8. The operator must perform daily maintenance and weekly maintenance (including lubrication) on the equipment according to "equipment management". Clean the dust and debris in the dust collector every week to avoid affecting the dust removal quality and ensure the integrity of the equipment.

9. Operators must implement civilized production and safe production while strictly implementing the handover system.10. When the work is over, immediately turn off the power switch of the unit to prevent the device from running. And clean up the work site.

Roller Conveyor Shot Blasting Machine

Roller Conveyor Shot Blasting Machine

What should I do if the shot blasting machine leaks oil? For the use of shot blasting machines, oil leakage often occurs. For example: oil leakage from the rotary shaft of the shot blasting machine engine, oil leakage from the engine of the shot blasting machine, etc. What should we deal with in the face of these sudden oil spills? First, let's talk about the shot blasting machine. The solution for oil leakage of the engine rotary shaft, the rotary shaft of the shot blasting machine includes the clutch handle shaft of the shift lever shaft of the starter and the pressure reducing shaft of the shot blasting machine.

Reasons and measures: If the shaft and the hole are worn out, the shifting lever shaft and the clutch handle shaft of the starter can be cut out on the lathe and the sealing ring of the corresponding size can be installed. If the aging of the decompression shaft is invalid, replace the new apron. How to deal with the oil leakage of the shot blasting machine engine switch. The switch includes water valve, fuel tank switch and gasoline switch. If the ball valve is worn or rusted, the rust between the ball valve and the seat hole should be removed, and a suitable steel ball should be selected instead. If the shot sealing machine engine packing and fastening threads are damaged, repair or replace the fasteners and replace the sealing packing. If the cone joint is not tight, it can be ground with fine valve sand and engine oil.

Hot Products

Request a Quote
Contact Us
Follow Us

Technical Support:

+86 152 6413 6591 sales@ccmachinery.cn